Disactivating The Rinse-Aid Function; Drain - Electrolux DIVA 60 cm Service Manual

6.10 Disactivating the rinse-aid function

Introduction of rinse-aid may be disactivated by the user by pressing a combination of buttons. In this case,
the Rinse-aid LED (if featured) will also be disactivated.
1. Cancel any cycles that may have been selected.
2. Press S0 to switch the appliance on.
3. Press buttons S2-S3 simultaneously, and hold down until LEDs LD1, LD2 and LD3 begin to flash.
4. Press button S2: LEDs LD1 and LD3 switch off, while LD2 continues to flash.
The condition of the function is indicated by the display: 1d rinse-aid function is operative, 0d rinse-aid
function is inoperative
5. Press button S2 again to disactivate/activate the rinse-aid function.
6. To store this setting in memory: press button S0 and switch the appliance off; alternatively, wait for 60
seconds (appliance in selection mode)

6.11 Drain

The drain pump (PS) is powered by triac TY3
(connector C1) and via the contacts of the
ON/OFF switch (PU) and the door switch (IP).
At the end of the drain phase, a control
procedure is performed to check that the
contact of the level pressure switch is open on
EMPTY. If this is the case, the appliance
proceeds to the subsequent phase.
If, as a result of a problem in the drain phase,
the pressure switch contact remains closed on
FULL (i.e. if there is water in the hydraulic
circuit), the drain phase is repeated.
On completion of this second drain phase, the
status of the pressure switch is again checked.
If it is still closed on FULL, alarm [i20] is
generated (failure to drain).
The time-out for each of these two phases is 120 seconds.
N.B. The washing programmes always begin with a drain phase.
SOI/DT 2003 - 01 eb 22 599 35 64-85