Information On Display Panel; Malfunctions - Siemens SN67ZX01CN User Manual

Information on display panel

Fault
Special salt refill indicator
lights up.
Refill indicator for special
salt does not light up.
Refill indicator for rinse aid
lights up.
Refill indicator for rinse aid
does not light up.
Display flashes.
Machine Care indicator
lights up.

Malfunctions

Fault
Water is left in the appliance
at the end of the pro-
gramme.
Cause
Insufficient special salt.
Sensor does not detect spe-
cial salt tablets.
Water softening system is
switched off.
Insufficient rinse aid.
Rinse aid system is switched
off.
Appliance door is not closed
properly.
Machine care is recommen-
ded.
Cause
Filter system or area under
the filters is blocked.
Programme has not yet
ended.
Troubleshooting en
Troubleshooting
Add "Special salt" → Page 29.
▶
Do not use special salt tablets.
▶
"Setting water softening system"
▶
→ Page 29
Add "Rinse aid" → Page 31.
1.
Set the amount of rinse aid to be
2.
dispensed.
→ "Setting the amount of rinse aid",
▶
Page 32
Close the appliance door.
▶
Arrange the tableware so
‒
that no parts project beyond
the basket and prevent the
appliance door from closing
properly.
Run the Machine Care programme
▶
without tableware.
Use a special machine care
‒
product.
The indicator will go out automatic-
ally after 3 wash cycles whether
Machine Care is carried out or not.
Troubleshooting
Clean the "Filters" → Page 42.
1.
Clean the "Wastewater pump"
2.
→ Page 56.
Wait until the programme ends or
▶
cancel the programme with reset.
→ "Terminate programme",
▶
Page 38
53