Siemens SN... Operating Instructions Manual
Hide thumbs
Also See for SN...:
- Instruction manual (56 pages) ,
- Operating instructions manual (46 pages) ,
- User manual (64 pages)
Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Siemens SN...
Summary of Contents for Siemens SN...
- Page 1 SN… SX…...
-
Page 3: Table Of Contents
Table of contents Cups and glasses ....13 Intended use ....4 Pans . -
Page 4: Intended Use
Intended use Cleaning and maintenance . . . 24 Intended use Overall condition of the machine . . . 24 u s e I n t e n d e d Special salt and rinse aid ..25 This appliance is intended for Filters . -
Page 5: Delivery
Safety instructions Delivery Ensure that the protective conductor system 1. Check the packaging and of the domestic supply has dishwasher immediately for been correctly installed. damage caused in transit. Do The electrical connection not switch on a damaged conditions must correspond appliance, but contact your with the specifications supplier. -
Page 6: In Daily Use
Safety instructions After installing the appliance, Activating the button lock: ensure that the plug is easily accessible. 1. Start the required programme. (See Electrical connection) 2. Hold down the button + for Some models: approx. 4 sec. until this The plastic housing on the indicated on the digital water connection contains display. -
Page 7: Disposal
Safety instructions If the fascia is damaged If the appliance (cracks, holes, broken is not in a cavity and a side buttons), do not operate the panel is accessible, the door appliance. Pull out the mains hinge area must be covered plug or switch off the fuse. -
Page 8: Protection Of The Environment
Protection of the environment Keep children away from Protection of the detergents and rinse aid. environment These may cause chemical burns in the mouth, throat r o n m e n t t h e e n v i i o n o f P r o t e c t and eyes or asphyxiation. -
Page 9: Getting To Know Your Appliance
Getting to know your appliance Appliance interior Getting to know your appliance 1" Interior light * a p p l i a n c k n o w y o u r n g t o G e t t i 1* Top basket Diagrams of the control panel 12 Knife shelf *... -
Page 10: Water Softening System/Special Salt
Water softening system/Special salt To change the setting: Water softening 1. Press programme button 3. system/Special salt Each time the button is pressed, the set value increases by one level; s a l t e m / S p e c i a l n g s y s t s o f t e n i W a t e r... -
Page 11: Detergents With Salt Component
Rinse aid ã 3. Then add dishwasher salt (not table Caution salt or tablets). Never fill the salt dispenser with The water is displaced and runs out. detergent. You will destroy the water softening system. As soon as the salt refill indicator @ on the fascia is lit, top up the salt. -
Page 12: Setting Amount Of Rinse Aid
Utensils 2. Carefully pour rinse aid up To change the setting: to the max. mark in the filler opening. 1. Press programme button 3. Each time the button is pressed, the set value increases by one level; when the value of : has been reached, the display jumps back (off). -
Page 13: Glass And Utensil Damage
Utensils Glass and utensil damage Unloading the dishwasher Causes: To prevent water from dripping off the upper basket onto the utensils in the Glass type and glass production lower basket, it is recommended process. to empty the appliance from the bottom Chemical composition of the detergent. -
Page 14: Pans
Utensils Pans Cutlery basket Bottom basket 1j You should always place cutlery unsorted with the points downwards. To prevent injuries, place long, pointed implements and knives on the knife shelf. Etagere * Etagere * Etagere * Et a g e r e Heavily soiled utensils (pans) should The etagere and the space underneath The etagere and the space underneath... -
Page 15: Folding Spikes
Utensils Folding spikes * Knife shelf * F o l d i n g s p i k e s K n i f e s h e l f * depending on model * depending on model The spikes can be folded down to Long knives and other utensils can be improve arrangement of pans, bowls arranged horizontally. -
Page 16: Detergent
Detergent Top basket with side levers Detergent 1. Pull out the top basket 1* out. D e t e r g e n t You can use tablets as well as powder 2. To lower the basket, press in the left or liquid detergents for dishwashers, but and then the right lever on the never use washing up liquid. -
Page 17: Adding Detergent
Detergent Adding detergent If the utensils are only lightly soiled, 1. If the detergent dispenser 9* is still slightly less than the indicated amount closed, press the lock 92 to open of detergent is usually adequate. the detergent dispenser. Suitable detergents and care products Pour detergent into the dry detergent can be purchased online dispenser 9* only (insert tablet flat,... - Page 18 Detergent Notes You will obtain optimum rinsing and drying results by using solo detergents and applying salt and rinse aid separately. If programmes are short, tablets may not have full cleaning effect due to different dissolving properties and there may even be undissolved detergent residue.
-
Page 19: Overview Of Programmes
Overview of programmes Overview of programmes p r o g r a m m e s O v e r v i e w o f The max. possible number of programmes is illustrated in this overview. The corresponding programmes and their arrangement can be found on the fascia. -
Page 20: Programme Selection
Additional options * The Intensive Smart 45° programme Additional options offers outstanding cleaning results even if utensils are heavily soiled. And this o p t i o n s o n a l A d d i t i with an energy saving of up to 25% * depending on model compared with the Intensive 70°... -
Page 21: Intensive Zone
Operating the appliance Ï Intensive zone * Operating I n t e n s i v e z o n e the appliance Perfect for a mixed load. You can wash very soiled pots and pans in the lower n c e a p p l i a n g t h e O p e r a t i... -
Page 22: Programme Sequence Indicator
Operating the appliance Timer programming * Note Ti m e r pr o g r a m mi n g - for environmentally friendly operation of the dishwasher: * depending on model For ecological reasons the Eco 50° You can delay the start of the programme is preset whenever the programme in 1-hour steps up to appliance starts. -
Page 23: Automatic Switch Off / Interior Light
Operating the appliance Automatic switch off after end To change the setting: 1. Press programme button 3. of programme or interior light* Au t o m a t i c s w i t c h o f f / in t e r i o r l i g h t Each time the button is pressed, the set value increases by one level;... -
Page 24: Terminating The Programme
Cleaning and maintenance T erminating the programme Intensive drying T e r m i n a t i n g t h e pr o g r a m me (Reset) The final rinse uses a higher temperature which improves the drying 1. -
Page 25: Special Salt And Rinse Aid
Cleaning and maintenance Filters Fill detergent dispenser with detergent. Start the appliance without utensils in the programme with The filters 1Z keep large foreign the highest rinsing temperature. objects in the rinsing water away from Clean the appliance with detergents/ the pump. -
Page 26: Spray Arms
Cleaning and maintenance Spray arms Limescale and contaminants in the rinsing water may block nozzles and bearings on the spray arms 1B and 1. Check outlet nozzles on the spray arms for blockages. 2. Unscrew the upper spray arm 1B. 3. -
Page 27: Fault, What To Do
Fault, what to do? 5. Prise out the white pump cover Fault, what to do? (as illustrated) using a spoon. Grip the cover on the crosspiece and lift o d o ? w h a t t F a u l t , diagonally inwards. -
Page 28: Fault Table
Fault, what to do? Fault table Fault Cause Remedial action “Check water supply” Supply hose kinked. Install supply hose without kinks. display 8 lights up. Tap turned off. Turn on the tap. Tap jammed or calcified. Turn on the tap. Flow rate must be min. - Page 29 Fault, what to do? Fault Cause Remedial action A different error code is A technical fault has probably Switch off appliances with the ON/OFF switch (. After a short time restart indicated on the digital occurred. display. the appliance. to : If the problem recurs, turn off the tap and pull out the mains plug.
- Page 30 Fault, what to do? Fault Cause Remedial action Utensils not dry. No or too little rinse aid Refill rinse aid. in the dispenser. Programme selected without Select programme with drying (see drying. Overview of programmes, Programme sequence). Water collecting in depressions Arrange utensils in a sloping position, on the utensils and cutlery.
- Page 31 Fault, what to do? Fault Cause Remedial action Food remnants Utensils placed too closely Arrange utensils with adequate clearance on the utensils. together, utensils basket between them ensuring that the spray jets overfilled. can reach the surface of the utensils. Prevent contact points.
- Page 32 Fault, what to do? Fault Cause Remedial action Water stains on plastic Droplet formation on plastic Use a more intensive programme (more parts surface is physically unavoidable. water changes). After drying, water stains are Arrange utensils in a sloping position. visible.
- Page 33 Fault, what to do? Fault Cause Remedial action Coloured (blue, yellow, Film formation consisting Can be partly removed with machine brown), difficult to remove of ingredients from vegetables cleaner or by mechanical cleaning. Coatings to non-removable coatings (e.g. cabbage, celery, potatoes, are harmless.
- Page 34 Fault, what to do? Fault Cause Remedial action Rust spots on the cutlery. Cutlery not adequately rust- Use corrosion-resistant cutlery. resistant. Knife blades are frequently more severely affected. Cutlery will also rust if rusting Do not wash rusting parts. parts are rinsed at the same time (pan handles, damaged utensil baskets, etc.).
- Page 35 Fault, what to do? Fault Cause Remedial action Appliance stops Door not closed properly. Close the door. in the programme or Do not place utensils or fragrance Check whether rear panel is being pressed programme is interrupted. dispenser in the tablet collecting in, e.g.
-
Page 36: Customer Service
Customer service Customer service Installation and connection e r v i c e C u s t o m e r s If you are unable to rectify the fault, i o n a n d c o n n e c t l a t i o n I n s t a l please contact your customer service. -
Page 37: Delivery
Installation and connection Delivery Installation Your dishwasher has been checked The required installation dimensions can thoroughly in the factory to ensure that it be found in the installation instructions. is in working order. This may cause Level the appliance with the aid of the small water stains. -
Page 38: Warm Water Connection
Installation and connection 5. Press programme button # until Water pressure: the factory set value : at least 0.05 MPa (0.5 bar), maximum is indicated on the digital 1 MPa (10 bar). At a higher water display )*. pressure: connect pressure-reducing valve ahead. -
Page 39: Removing The Appliance
Installation and connection Removing the appliance Protection against frost Pr o t e c t i o n a g a i n s t fr o s t ( E m p t y i n g t h e a p p l i a n c e ) Also observe If the appliance is in a room where there the sequence of worksteps here. - Page 42 *9000843617* 9000843617 en (9210-1) 640MG...