Installing The Dryer - Speed Queen KES18AWF Installation Instructions Manual

Installing the Dryer

Step 1: Position and Level the Dryer
Install dryer before washer. This allows room for
attaching exhaust duct.
Select a location with a solid floor. Dryers installed in
residential garages must be elevated 18 inches (46 cm)
above the floor.
A
FRONT VIEW
Area
A
B
C
D
E
**NOTE: For new installations, locate top of wall vent 42 inches (106.7 cm) above floor to make venting
easier to connect.
512063
A
Description
Dryer sides and rear clearance
Dryer top (Rear 24 in.)
Dryer rear
Dryer Top (Front 4 in.)
Exhaust duct clearance to combustible material 2 in. (5.1 cm)
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
No other fuel burning appliance should be installed in
the same closet with the dryer.
The dryer must not be installed or stored in an area
where it will be exposed to water and/or weather.
The dryers needs sufficient clearance and an adequate
air supply for proper operation and ventilation, and for
easier installation and servicing. (Minimum clearances
are shown below).
D
SIDE VIEW
0 in. (0 cm)
12 in. (30.5 cm)
.4 in. (10.2 cm)
.5 in. (1.3 cm)
Figure 2
B
E
E
C
OUTER WALL OF
ENCLOSURE
DRY2060N
Closet Installation
DRY2053N
5