Installing The Dryer - Speed Queen AES28AWF Installation Instructions Manual

Installing the Dryer

Step 1: Position and Level the Dryer
Install dryer before washer. This allows room for
attaching exhaust duct.
Select a location with a solid floor. Dryers installed in
residential garages must be elevated 18 inches (46 cm)
above the floor.
B
A
FRONT VIEW
(w/o Closet Door)
Area
Dryer sides and rear clearance
A
Dryer top clearance
B
Dryer front clearance
C
Exhaust duct clearance to
D
combustible material
Weather hood to ground clearance
E
Distance from floor or ceiling to
F
hole edge
Area of centered air openings in
G*
closet door
*Louvered door with equivalent air openings is acceptable. (Minimum clearances are shown.)
1 Closet Door
2 Centered Air Openings (G) (2 Openings
minimum)
3 Outer Wall of Enclosure
**NOTE: For new installations, locate top of wall vent 42 inches (106.7 cm) above floor to make venting
easier to connect.
512061
1
C
A
(Closet Door)
Description
0 in. (0 cm)
12 in. (30.5 cm)
Not Applicable
2 in. (5.1 cm)
12 in. (30.5 cm)
Not Applicable
Not Applicable
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
No other fuel burning appliance should be installed in
the same closet with the dryer.
The dryer must not be installed or stored in an area
where it will be exposed to water and/or weather.
The dryers needs sufficient clearance and an adequate
air supply for proper operation and ventilation, and for
easier installation and servicing. (Minimum clearances
are shown below).
E
D
A
**42 in.
(106.7 cm)
SIDE VIEW
3
Free Standing/Alcove
Installation
Figure 2
F
2 (G)
F
FRONT VIEW
(Closet Door)
Closet Installation
0 in. (0 cm)
12 in. (30.5 cm)
2 in. (5.1 cm)
2 in. (5.1 cm)
12 in. (30.5 cm)
3 in. (7.6 cm)
40 sq. in./open (260 sq. cm)
D823I
5