Step 2: Connect Dryer Exhaust System - Speed Queen CES68AWF Installation Instructions Manual

Place the dryer in position, and adjust the legs until the
dryer is level from side to side and front to back. The
dryer must not rock.
1
1 Dryer Base
2 Level
3 Leveling Leg
Figure 3
IMPORTANT: In mobile home installations, gas
dryers MUST be permanently attached to the floor
at the time of installation. Order No. 526P3 Dryer
Installation Kit (available at extra cost) for a
manufactured (mobile) home installation. Follow
the instructions supplied with the kit.

Step 2: Connect Dryer Exhaust System

WARNING
To reduce the risk of fire and combustion
gas accumulation the dryer MUST be
exhausted to the outdoors.
To reduce the risk of fire and the
accumulation of combustion gases, DO NOT
exhaust dryer air into a window well, gas
vent, chimney or enclosed, unventilated
area, such as an attic, wall, ceiling, crawl
space under a building or concealed space
of a building.
6
2
3
DRY2050N
DRY2050N
W604
W045
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
WARNING
This gas appliance contains or produces a
chemical or chemicals which can cause
death or serious illness and which are
known to the State of California to cause
cancer, birth defects, or other reproductive
harm. To reduce the risk from substances in
the fuel or from fuel combustion, make sure
this appliance is installed, operated, and
maintained according to the instructions in
this manual.
To reduce the risk of fire, DO NOT use
plastic or thin foil ducting to exhaust the
dryer.
• DO NOT use plastic or thin foil ducting. Rigid
metal duct is recommended.
DO
Figure 4
• Locate dryer so exhaust duct is as short as
possible.
• Be certain old ducts are cleaned before installing
your new dryer.
• Use 4 inch (102 mm) diameter rigid or flexible
metal duct.
• The male end of each section of duct must point
away from the dryer.
• Use as few elbows as possible.
• Use duct tape or pop-rivets on all duct joints.
• Ductwork that runs through unheated areas must
be insulated to help reduce condensation and lint
build-up on pipe walls.
W115
W354
DRY688N
DON'T
DRY688N
512100