Table of Contents
Advertisement
Safety
Latch
Spray
Gun
High Pressure
Hose
STEP 1: Attach the high pres-
sure hose to the spray gun
using teflon tape on hose
threads.
DipStick
Oil Window
STEP 4: Remove shipping
cap and install oil dipstick.
Check pump oil level by using
dipstick or observe oil level in
oil window (if equipped). Use
30 wt. non detergent oil.
Pump
Water Inlet
STEP 7: Connect the garden hose
to pump water inlet. Inspect inlets.
CAUTION : Do not run the pump
without water or pump damage
will result.
ASSEMBLY INSTRUCTIONS
Soap
Nozzle
STEP 2: Pull the spring-loaded collar
of the wand coupler back to insert your
choice of pressure nozzle.
Coupler Collar
High Pressure Hose
STEP 5: Connect the high pressure
hose to the pump discharge fitting. Push
coupler collar forward until secure.
Garden
Hose
9.800-079.0 • Rev. 01/18
Wand
Coupler
STEP 3: Release the coupler collar
and push the nozzle until the collar
clicks. Pull the nozzle to make sure it
is seated properly.
Discharge Fitting
STEP 6: Connect garden hose to the
cold water source.
Pressure
Nozzle
Wand
Coupler
Wand
Collar
Cold
Water
Source
Garden
Hose
7
Advertisement
Table of Contents
