Assembly Instructions - Kärcher HDS 2.6/30 P Cage Operator's Manual

Spray
gun
Safety
Latch
high Pressure
hose
STEP 1: Attach the high
pressure hose to the spray
gun using teflon tape on hose
threads.
dipStick
Oil Window
STEP 4: Remove shipping cap
and install oil dipstick. Check
pump oil level by using dipstick
or observe oil level in oil win-
dow (if equipped). Use 30 wt.
non detergent oil.
Pump
Water Inlet
STEP 7: Connect the garden hose
to pump water inlet. Inspect inlets.
CAUTION: Do not run the pump
without water or pump damage
will result.

ASSEMbLy INSTRUCTIONS

Soap
Nozzle
STEP 2: Pull the spring-loaded collar
of the wand coupler back to insert your
choice of pressure nozzle.
Coupler Collar
high Pressure hose
STEP 5: Connect the high pressure
hose to the pump discharge fitting. Push
coupler collar forward until secure.
garden
hose
9.800-079.0 •
Wand
Coupler
STEP 3: Release the coupler collar
and push the nozzle until the collar
clicks. Pull the nozzle to make sure it
is seated properly.
discharge fitting
STEP 6: Connect garden hose to the
cold water source.
Rev. 04/09
Pressure
Nozzle
Wand
Coupler
Wand
Collar
Cold
Water
Source
garden
hose
7