Table of Contents
Advertisement
STEP 1: Remove detergent suction
tube from container and insert into
1 gallon of fresh water.Turn variable
pressure wand handle for low pres-
sure or connect the black detergent
nozzle. Pull trigger on spray gun and
siphon water for one minute.
STEP 4: Press
STEP 5: Disconnect the gar-
trigger to release
den hose from the water inlet
water pressure.
on the machine.
CAUTION: Always store your pressure washer in a
location where the temperature will not fall below
32°F (0°C). The pump in this machine is susceptible
to permanent damage if frozen. FREEZE DAMAGE
IS NOT COVERED BY WARRANTY.
1. Stop the pressure washer, squeeze spray gun trig-
ger to release pressure.
2. Detach water supply hose and high pressure hose.
3. Turn on the machine for a few seconds, until re-
maining water exits. Turn engine off immediately.
4. Drain the gas and oil from the engine.
5. Do not allow high pressure hose to become kinked.
6. Store the machine and accessories in a room which
does not reach freezing temperatures.
CAUTION: Failure to follow the above directions will
result in damage to your pressure washer.
When the pressure washer is not being operated or is
being stored for more than one month, follow these
instructions:
1. Replenish engine oil to upper level.
2. Drain gasoline from fuel tank, fuel line, fuel valve
and carburetor.
3. Pour about one teaspoon of engine oil through
the spark plug hole, pull the starter grip several
times and replace the plug. Then pull the starter
grip slowly until you feel increased pressure which
SHUTTING DOWN AND CLEAN-UP
STEP 2: Turn off the engine.
Water
Inlet
STORAGE
9.800-079.0 • Rev. 01/18
On-Off
Switch
High Pressure
Outlet
STEP 6: Disconnect the high
pressure hose from high pres-
sure outlet.
indicates the piston is on its compression stroke and
leave it in that position. This closes both the intake
and exhaust valves to prevent rusting of cylinder.
4. Cover the pressure washer and store in a clean, dry
place that is well ventilated away from open flame
or sparks. NOTE: The use of a fuel additive, such
as STA-BIL
, or an equivalent, will minimize the
®
formulation of fuel deposits during shortage. Such
additives may be added to the gasoline in the fuel
tank of the engine, or to the gasolinee in a storage
container.
After Extended Storage
CAUTION: Prior to restarting, thaw out any pos-
sible ice from pressure washer hoses, spray gun
or wand.
Engine Maintenance
During the winter months, rare atmosheric
conditions may develop which will cause an icing condi-
tion in the carburetor. If this develops, the engine may
run rough, lose power and may stall. This temporary
condition can be overcome by deflecting some of the
hot air from the engine over the carburetor area. NOTE:
Refer to the engine manufacturer's manual for service
and maintenance of the engine.
STEP 3: Tur n off water
supply.
Safety
Latch
STEP 7: Engage the
spray gun safety lock.
11
Advertisement
Table of Contents
