Olivetti PG L2435 Operation Manual page 149

>TCP/IP
? Off
>>DHCP
? Off
>>Auto-IP
? Off
7-42
IMPORTANT The DHCP, IP address, subnet mask, gateway and
Bonjour menu options for TCP/IP are displayed when TCP/IP is en-
abled.
1
Press  while Network > is displayed.
2
Press  or  repeatedly until >TCP/IP > appears.
3
Press [OK]. A blinking question mark (?) appears.
>
4
Select On or Off using  or .
5
Select On and press [OK]. Configure the settings shown below.
DHCP (DHCP setting)
DHCP (Dynamic Host Configuration Protocol) is the protocol that
assigns the information required to establish a network connection when
a host attempts to connect to the network (Internet). This information
includes the IP address of the local node and the default router (the
router in the host's own network system) and the DNS (Domain Name
System) server. DHCP is an extension of the BOOTP (Bootstrap) startup
protocol.
1
Press  while >TCP/IP
2
Press  or  repeatedly until >>DHCP appears.
3
Press [OK]. A blinking question mark (?) appears.
4
Select On or Off using  or .
5
Press [OK].
6
Press [MENU]. The display returns to Ready.
Auto-IP (Auto-IP setting)
This protocol is used for automatic assignment of an IP address when
you connect to a small network that does not have a DHCP server.
Select an address from the range 169.254.0.1 to 169.254.255.254, and
if no other device on the network is using that address, it is used as your
address.
1
Press  while >TCP/IP
2
Press  or  repeatedly until >>Auto-IP appears.
3
Press [OK]. A blinking question mark (?) appears.
4
Select On or Off using  or .
5
Press [OK].
6
Press [MENU]. The display returns to Ready.
On > is displayed.
On > or >TCP/IP Off > is displayed.
Using the Operation Panel