Siemens TP27 Equipment Manual page 206

System Messages
Message Cause
510 Data record not present.
512 Configured data block length is too short.
The variable transferred with the message identifies the
number of the data block.
541 ... Specified variable not available on PLC
550
551 An MPI/PPI connection to the PLC cannot be established
using the specified station address.
552 Query: safety check as to whether the selected data re-
cord is to be deleted. The data record is only deleted if 0
is entered. If not the function is cancelled.
553 Information message: selected data record has been de-
leted.
554 Query: 1st safety check as to whether the data medium
for storing data records is to be formatted. Any data re-
cords already on the disk will be deleted when the func-
tion is executed! The function is only executed if 0 is
entered.
555 Query: 2nd safety check as to whether the data medium
for storing data records is to be formatted. Any data re-
cords already on the disk will be deleted when the func-
tion is executed! The function is only executed if 0 is
entered.
556 Information message: disk has been formatted.
557 Query: if 0 is entered the data record will be adopted
with the new values. If anything else is entered, you may
continue editing.
558 Query: if 0 is entered the edited data record is rejected.
The data remains as it was before editing. If anything
else is entered, you may continue editing.
559 Query as to whether the event message buffer should be
cleared.
560 Query as to whether the alarm message buffer should be
cleared.
561 A global data record (rel. 3.0 or higher) is being edited
and does not have all the entries defined in the current
recipe.
562 Information as to which mode was set using the function
"First/Last Message".
563 Information as to which mode was set using the function
"First/Last Message".
564 Query: if 0 is entered the data record is created. If any-
thing else is entered, the function is cancelled.
C-8
Remedy:
A process link with a non-existent data
block has been configured in a recipe or
the recipe data contains errors.
Change configuration and retransfer.
Change configuration and retransfer.
Check MPI station addresses and wiring.
This query is also used when backing up or
restoring configurations. In that case, it re-
lates to deletion of all data records in the
system memory.
The data record can only be saved if the
marked entries are edited. If no entries are
marked, only the version number has
changed.
TP27, TP37 Equipment Manual
Release 01/00