Table of Contents
Advertisement
Restore firmware/
Proceed as follows to restore a firmware/configuration backup on the Touch
configuration
Panel:
Load configuration
In order to load the configuration on another unit which is not locally availa-
in another unit
ble, proceed as follows:
Note
It is advised against downloading the configuration directly onto the memory
card because the memory location organization differentiates between memo-
ry card and (target) flash which may lead to problems.
Automatic restore
If the Backup/Restore function is added to "initialization" entry point in the
firmware/
configuration, the function is called in each time the Touch Panel is started
configuration
upaufgerufen. The system then asks whether the internal flash memory should
be overwritten by the data stored on the memory card.
TP27, TP37 Equipment Manual
Release 01/00
Step
1
Insert the memory card with the firmware/configuration in Slot B
of the Touch Panel.
2
Restart the TP37. The Touch Panel starts up wih the
firmware/configuration contained on the memory card.
3
Start the restore function by touching the corresponding button on
the Backup/Restore standard screen. The memory contents of the
internal flash memory are overwritten by the
firmware/configuration contained on the memory card.
Step
1
Firstly, download the configuration in the internal flash of the
available unit.
2
Then transfer the configuration to the memory card (refer to
procedure Backup flash
3
Following that, load the file in the other unit according to the
procedure Restore firmware/configuration.
Step
1
Insert the memory card containing the backup into Slot B of the
system.
2
Start up the Touch Panel.
3
Confirm that the restore function should be started by answering
"OK" at the prompt.
4
Remove the memory card from the TP37.
Storing and Loading Data
Action
Action
module).
Action
9-7
Advertisement
Table of Contents
