Table of Contents
Advertisement
Steps
1. Using the alignment posts and rubber grommets, place the speakers on the slots of the palm-rest and keyboard assembly.
2. Route the speaker cable through the routing guides on the palm-rest and keyboard assembly.
3. Adhere the tapes that secure the speaker cable to the battery.
4. Replace the two screws (M2x2) that secures the speakers to the palm-rest and keyboard assembly.
5. Connect the speaker cable to the system board and adhere the tape that secures the speaker cable to the system board.
Next steps
1. Install the
base
cover.
2. Follow the procedure in
I/O board
Removing the I/O board
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the
right
fan.
About this task
The following image indicates the location of the I/O board and provides a visual representation of the removal procedure.
NOTE:
The I/O board consists of the SD-card reader and the audio board.
36
Removing and installing components
After working inside your
Before working inside your
computer.
computer.
Advertisement
Table of Contents
