Removing Drawers; Removing Slides; Changing The Back-Up Batteries - Follett K25541 Installation, Operation And Service Manual

Removing Drawers

1. Pull drawer forward to stop (Fig. 39.1).
2. Lift drawer front to free front rollers from sides (Fig. 39.2).
3. Still lifted, pull drawer forward to free back rollers from sides
(Fig. 39.3).

Removing Slides

1. Push slides all the way back.
2. Swing bottom of slide away from refrigerator wall and lift slide off
of rollers.

Changing the back-up Batteries

1. Provide power to the unit and turn the power switch to the ON
position.
2. Prop the door open so it doesn't close during the battery
change.
3. Turn power switch to the OFF position and unplug the unit from
the power supply.
4. Remove the four screws (Fig. 40.1) on the kick panel at the
bottom of the unit.
5. Remove the kick panel and slide the panel to the right of the
refrigerator.
Note: Take care when removing, some wires are connected to the
kick panel (Fig. 40.2).
6. Find the control module on the left-hand side of the unit, just to
the left of the condenser.
7. Open the Velcro strap that holds the battery pack and the
battery connector.
8. Remove the battery pack.
9. Disconnect the connector to the battery pack.
10. Remove the eight AA batteries from the battery pack.
11. Install eight NEW AA batteries into the battery pack.
12. Re-connect the battery connector with the black and red wires
to the top of the battery pack.
13. Place the battery pack back in place on the control module and
tighten the Velcro strap around the battery pack.
14. Re-install the kick plate.
15. Close the door and check to make sure that the wire on the
hinge side of the door is not kinked and slides freely in the strain
relief.
16. Test operation of the keypad lock while the power to the unit is
OFF to confirm back-up battery connection.
17. Turn the power switch ON or plug the unit back into the power
supply.
REF4P, REF5P and REF5BBP-T Undercounter Refrigerators
Fig. 39
3
1
2
Fig. 40
3
2
1
2
29