Table of Contents
Advertisement
•
Remove remaining food from the items.
•
Make soft the remaining burned food on the items.
•
Put hollow items (cups, glasses and pans) with the
opening down.
•
Make sure that cutlery and dishes do not bond
together. Mix spoons with other cutlery.
•
Make sure that glasses do not touch other glasses.
•
Put small items in the cutlery basket.
•
Put light items in the upper basket. Make sure that
the items do not move.
•
Make sure that the spray arm can move freely
before you start a program.
Before starting a programme
Make sure that:
•
The filters are clean and correctly installed.
•
The spray arms are not clogged.
•
There is dishwasher rinse aid (unless you use multi-
tablets).
Care and cleaning
Warning! Before maintenance,
deactivate the appliance and disconnect
the mains plug from the main socket.
Cleaning the filters
C
•
Make sure that there are no residues of food or soil in or around the edge of the sump.
•
Put back in place the flat filter (C). Make sure that it is correctly positioned under the 2 guides.
•
Reassemble the filters (A) and (B).
•
Put back the filter (A) in the flat filter (C). Turn it clockwise until it locks.
An incorrect position of the filters can cause bad washing results and damage to the appliance
•
The position of the items in the baskets is correct.
•
The programme is applicable for the type of load
and for the degree of soil.
•
The correct quantity of detergent is used.
Unloading the baskets
1. Let the tableware cool down before you remove it
from the appliance. Hot items can be easily
damaged.
2. First remove items from the lower basket, then from
the upper basket.
At the end of the program water can still
remain on the sides and on the door of
the appliance.
For the better drying results open the
door 5-10 cm and allow tableware to cool
down for 30-40 min.
Dirty filters and clogged spray arms
decrease the washing results. Make a
check regularly and, if necessary, clean
them.
B
A
11
Advertisement
Table of Contents
