Miele TXI 680 WP Operating Instructions Manual page 80

Installation
Changing the door hinging
You can change the door hinging on
this tumble dryer yourself.
For safety reasons, the tumble dryer
must be disconnected from the elec-
tricity supply before changing the
door hinging.
You will need:
- a Torx T20 and T30 screwdriver
- a flat head screwdriver or pointed pli-
ers
- the lock catch cover supplied
- the door hinge cover supplied
- a soft surface (e.g., a blanket)
Changing the hinging over
1. Remove the door from the tumble
dryer
 Open the door.
 Use a T30 Torx screwdriver to un-
screw the two screws on the base
plate of the door hinge .
The door cannot fall off.
80
 Hold the door securely and pull it for-
wards: to remove the door you will
need to pull the base plate of the
hinge with its 2 pins out of the dryer.

To avoid scratching the door,
place it outer side downwards on a
soft surface (e.g., a blanket).
2. Change over the door lock on the
dryer
 Use a Torx T30 screwdriver to un-
screw the two screws on the door
lock .
 Use the screwdriver to press the door
lock upwards.
The door lock will spring out of its posi-
tion and can then be removed.