Miele TXI 680 WP Operating Instructions Manual page 59

Heat-pump dryer
Hide thumbs Also See for TXI 680 WP:
Table of Contents

Advertisement

Message
Empty container See
 lights up after
a program has
been canceled.
Soft Steam
Open & close door
Blockage detected.
See 
lights up
after a program
has been inter-
rupted.
 Service Fault F
lights up af-
XXX
ter a program
has been inter-
rupted.
Frequently Asked Questions
Possible cause and solution
The condensed water container is full or there is a
kink in the drain hose.
 Empty out the condensed water container.
 Check the drain hose.
To switch the fault message off:
 Open and close the door while the dryer is
switched on or switch the dryer off and back on
again.
This is to remind you that water is taken from the
condensed water container when the
gram is being used. The condensed water container
must be filled with water to at least the –min–
marker.
 Fill the condensed water container.
To switch off the message:
 Confirm with OK.
This it to remind you to load the laundry when the
SoftSteam
program is selected.
 Load the laundry in the drum.
The laundry is unevenly distributed or has rolled up.
 Open the door and untangle the laundry, and re-
move a few items, if necessary.
 Switch the dryer off and then on again.
 Start a program.
There is no obvious cause.
 Switch the dryer off and then on again.
 Start a program.
If the program is interrupted again and an error mes-
sage appears, there is a fault. Contact Miele Service.
Soft Steam
pro-
59

Advertisement

Table of Contents
loading

Table of Contents