Lincoln Electric VRTEX TRANSPORT+ Operator's Manual page 22

VRTEX 360, 360+, TRANSPORT, TRANSPORT+
®
UNIGUN DEVICE - VRTEX TRANSPORT ONLY
The Unigun device contains a swappable head to allow switching
between GMAW, GTAW and SMAW. The GMAW configuration has a
trigger that is used during the simulation to initiate and maintain the
simulated welding arc. The SMAW configuration has a stationary rod
that represents a stick electrode. This rod will appear and decrease
in length when welding in the virtual environment.
Figure 10 – Unigun device
HEADSET
HEAD SIZE ADJUSTMENT: To adjust the headset size, losen
the straps on the sides and top. Put on the headset starting with the
back strap then move the front display down over the eyes. Hold the
display and adjust the straps until snug.
IMAGE ADJUSTMENT: If the image appears blurry, a small
slider on the bottom of the headset can be moved to adjust the
display.
EARPHONES: Adjust the earphones to fit over the ears. Volume
can be changed in the software.
Figure 11 – Headset components
IMAGE
SLIDER
COUPON COMPARTMENT
The coupon compartment, in the stand, houses the physical coupons.
When not in use, the coupons should be stored in the compartment
and/or in the front storage drawer. Each coupon fits in its own area
defined by the foam located in the compartment.
COUPONS
The coupons represent the various workpieces on which the user
can virtually weld. During the virtual welding process, they provide
physical feedback to the student.
There are seven VR Coupons:
1. Flat Plate
2. T-Joint
3. V Groove
4. 2" Pipe XXS
5. 6" Pipe Schedule 40
6. Lap Joint
7. Pipe On Plate
ADJUSTMENT
STRAPS
EARPHONES
The coupons along with all VR devices have been factory calibrated
by The Lincoln Electric Company.
13
Figure 12 – Coupon compartment
Figure 13 – VR Coupons
7
5
4
1
INSTALLATION
6
2
3