Table of Contents
Advertisement
■ Trigger by GPIO
GPIO
3.7.3 Snapshot Tab
The Snapshot tabbed pane sets the camera to take snapshot images when motion is detected.
The four methods available for selection are Always, Schedule, Motion, and GPIO, each of
which can be set up with user scheduled recording time and duration, as well as defining the
video record file target destination.
■ Trigger by Always
Always
2 Mega-pixel PoE / Wireless Fish-Eye IP Camera
On the defined days of the week and at certain time of the set days,
the Camera will trigger its GPIO Input Signal when its state
changes. Recording duration can be set in seconds and the video
record may be provided to host by e-mail/FTP, stored in the SD
card, activated GPIO Output Port or through all of them.
Under this method, the camera automatically continues to capture
6 snapshots of the area under surveillance at every 1 or 2 seconds
at intervals. Three previous snapshot frames are collected from the
Camera buffer and 3 snapshot frames are captured live. The
stream of accumulated snapshots may be sent to host by e-mail or
FTP, or stored in the SD card as preferred.
52
ICA-8200/ICA-W8200
Advertisement
Table of Contents
