Table of Contents
Advertisement
EN
FUNCTION LIST
Once you have selected the model number you want to use and have defined the aircraft type, wing and tail type and other details in the
System Setup menu, use the Function list to define the details specific to your model's setup such as servo travel, reversing, mixing, etc.
The Main Screen appears when you power on the transmitter. Press the scroll wheel once to display the Function List.
Servo Setup
The Servo Setup menu contains the following functions:
• Travel Adjust
• Reverse
• Sub-Trim
• Channel Name
Travel Adjust
Travel Adjust sets the overall travel or endpoints of the servo arm
movement.
To adjust travel values:
1. Scroll to the channel you wish to adjust and press the scroll
wheel. When adjusting travel values assigned to a control stick:
a. Center the control stick to adjust both directions at the
same time.
b. To adjust travel in one direction only, move the control stick
in the direction you wish to adjust. Continue holding the
control stick in the desired direction while you are adjusting
the travel value.
2. Scroll left or right to adjust the travel value. Press the scroll
wheel to save the selection.
IMPORTANT: ALT, ROL, PIT and YAW replaces THR, AIL, ELE
and RUD channels in multirotor to more closely reflect the flight
axis in the multirotor aircraft. This change is throughout the
multirotor menu options.
Sub-Trim
Sub-Trim adjusts the servo travel center point.
NOTICE: Use only small sub-trim values or you may cause
damage to the servo.
Reverse
Use the Reverse menu to reverse the channel direction. For
example, if the elevator servo moves up and it should move down.
To reverse a channel direction:
1. Scroll to Travel and press the scroll wheel. Scroll left until
Reverse appears and press the scroll wheel again to save the
selection.
2. Scroll to the channel you wish to reverse and press the scroll
wheel.
If you reverse the Throttle channel, a confirmation screen appears.
Select YES to reverse the channel. A second screen appears,
reminding you to bind your transmitter and receiver.
30
Press
CAUTION: Always rebind the transmitter and receiver
after reversing the throttle channel. Failure to do so will
result in the throttle moving to full throttle if failsafe activates.
Always perform a control test after making adjustments to confirm
the model responds properly.
CAUTION: After adjusting servos, always rebind the
transmitter and receiver to set the failsafe position.
SPEKTRUM NX7e • TRANSMITTER INSTRUCTION MANUAL
Advertisement
Table of Contents
