Toro 72958 Operator's Manual page 67

Figure 100
1. 7.6 cm (3 inch) at position
A is correct
2. 8.3 cm (3-1/4 inch) at
position B is correct
10. Fine-tune the adjustment nut on the front
deck-lift assembly by turning it
Note:
To increase the height, turn the
adjustment nut clockwise; to decrease the
height, turn the nut counterclockwise.
Note:
If the front deck links do not have enough
adjustment to achieve accurate cut height, you
can use the single-point adjustment to gain
more adjustment.
Figure 101
1. Whizlock nut
2. Adjuster screw
11. To adjust the single-point system, loosen the
2 bolts at the bottom of the height-of-cut plate
(Figure 102).
g009196
3. Measure here from the
blade tip to the hard
surface
4. Measure at position A and
B on both sides
(Figure 101).
g010251
3. Jam nut
4. Yoke
1. Bolts at the bottom of the height-of-cut plate
12. If the deck is too low, tighten the
single-point-adjustment bolt by rotating it
clockwise. If the deck is too high, loosen
the single-point-adjustment bolt by rotating it
counterclockwise
Note:
Loosen or tighten the single-point
adjustment bolt enough to move the
height-of-cut plate mounting bolts at least 1/3
the length of the available travel in their slots.
This regains some up and down adjustment on
each of the 4 deck links.
1. Single-point adjustment bolt
13. Tighten the 2 bolts at the bottom of the
height-of-cut plate
Note:
In most conditions, the back blade tip
should be adjusted 6.4 mm (1/4 inch) higher
than the front.
67
Figure 102
(Figure 103).
Figure 103
(Figure 102).
g027345
g017036