Mitsubishi Electric s-MEXT-G00 006-044 Operation Manual page 10

UM_s-MEXT_ME28relC_00_12_19_ML
Mask of the terminal
8 LAN 1: 2:
4: 5:
7: 8:
10:
9 99.9 99.9
99.9 99.9
99.9 99.9
99.9LAN:Local Unit
Temp.(°C)
10 LAN 1: 2:
4: 5:
7: 8:
10:
11 01 LAN APL
Current 0020 Pa
Target 0020 Pa
APL
Local 0019 Pa
Status
On target
12 Target
02500 m3/h
Current
02000 m3/h
Status
In Regulation ...
13 Target
0020 Pa
Current
0020 Pa
Status
On target
14 DT 03.0
T.INT
24.0
Status Enabled
Position ALL INTERNAL
000%
15 000.0kg/h
A 00.0
µS/cm000
Alarm
code:00
16 Energy Management
Voltages (V)
Current (A)
Active Power(kW)0000.0
USER MANUAL
Description of the mask
3: Local network (LAN) status display mask. This mask is displayed only at the Master unit (LAN
address=1). Visible if the local network (LAN) is configured
6:
Unit operating
9:
Unit not operating
If the ADL LAN function is enabled:
99.9 Mask that displays all the temperature values read by the units on the pLAN network. This mask is
displayed only at the Master unit (pLAN address=1).
99.9
Visible if the pLAN is configured
99.9
3: Local network (LAN) status display mask. This mask is displayed only in the Slave unit (LAN
address=2÷10).
6:
Visible if the local network (LAN) is configured
9:
Unit operating
APL pLAN function operation status display mask. This mask is displayed for all the units (pLAN
address=1 to 10).
Visible if the pLAN is configured and the APL function is active
0020 Pa
Constant Capacity operation display mask.
Visible if the function is configured
Constant Head operation display mask.
Visible if the function is configured
Direct Free Cooling function operation display mask.
Visible if the function is configured
T.EXT
Shows Internal T, external T and Direct Free Cooling enable
21.0
Damper position (internal only, mixing, external only) and opening percentage
The image graphically describes the Free Cooling damper position:
Humidifier operation status display mask.
Visible if humidifier is present
Warning
code:0
Display mask for the values detected by the network transducer in case on mono-phase circuit.
000
Visible if the network transducer is present and configured
000.0
Unit in stand by Unit in rescue mode
Unit with Hot-Spot protection
ADL enabled
Unit not operating
TRANSLATION OF THE ORIGINAL INSTRUCTIONS
36
Unit with Cold-Spot protection
ADL operating limit reached