Microsoft XBOX CONTROLLER Repair Instructions page 51

Hide thumbs Also See for XBOX CONTROLLER:

4. Install Palm Motors

Gently press each palm rumble motor into the mid-frame. A plastic pry tool may be

required to gently bend the retention clip back.

NOTE:

The motors are soldered to the main board. This solder connection is very

fragile at both the motor and board ends. Take care not to damage the soldered

connection.

5. Route Wires

Repeating in reverse step 6 of the removal instructions, reroute the trigger motor wires

through the side clip, and through the mid-frame retention tabs up to the triggers.

IMPORTANT:

wire route to ensure wire length at the triggers is short enough to not be pinched

at a later step.

6. Install Trigger Motors

Install the trigger motors in the housing, with wires facing towards the center of the

mid-frame.

NOTE:

The motors are soldered to the main PCBA. This solder connection is very

fragile at both the motor and PCBA ends. Take care not to damage the soldered

connection.

Leave about 1 in. (25mm) of wire on the mainboard portion of the

Table of Contents