Graco GM 3500 Instructions-Parts List Manual page 27

CLAMP
NOTE: A standard steering wheel puller is required to re-
move the clamp. Two 1/4–28 x 3 or 4 in. long
screws are also needed.
NOTE: Refer to Fig 27–1.
1. Loosen the two screws (16) on the clamp (3), working
through the slot at the bottom of the clutch housing
(2).
2. Install two screws (B) of the tool (A) in two of the
threaded holes in the clamp. Tighten the screws (C)
until the clamp comes off.
3. Skip ahead to Reassembly, page 28, Step 3, or con-
tinue to the right.
2
B
C
A
Fig 27–1
NOTE: Refer to Fig 27–2.
1. Remove the four capscrews (8) and lockwashers (48)
2. Remove the engine key (13).
3. Pull off the clutch housing (2).
4. Skip ahead to Reassembly, page 28, Step 1, or con-
8
3
Fig 27–2
16
TORQUE TO
125 in–lb
(14 N.m)
CLUTCH HOUSING
which hold the clutch housing (2) to the engine (1).
tinue on page 30.
1
2
48
13
0156