Graco GM 3500 Instructions-Parts List Manual page 25

NOTE: The engine must be removed before the
Field, Clamp or Clutch Housing can be
removed.
1. Working under the mounting plate (A) of the
cart, remove the screw (15), lockwasher
(80) and washer (34) which hold the clutch
housing (2) to the cart. See Fig 25–1.
2. Still working under the mounting plate, re-
move the two locknuts (61 or 100) and lock-
washers (9), and then pull the screws (14)
out of the base of the engine. Disconnect the
red wire from the engine lead (B). Discon-
nect the black and white wires (29) from the
field. Pull the wires carefully through the
grommets (66) before removing the engine.
See Fig 25–1 and 25–2.
3. Lift the engine carefully and place it on a
work bench.
4. Remove the Field and Wiring Harness,
Clamp and Clutch Housing, as instructed
on pages 26 and 27.
5. Skip ahead to Reassembly, page 28, Step
1.
NOTE: All service to the engine must be per-
formed by an authorized HONDA
dealer.
WHITE
BLACK
VIEW FROM UNDER ENGINE MOUNTING
PLATE ON UPRIGHT CART
Fig 25–2
ENGINE
11
2
29
A
34
80
15
Fig 25–1
66
29
TO FIELD
TO ENGINE
61,9
RED
32
10
9,62
66
BLACK
VIEW FROM UNDER ENGINE MOUNTING
PLATE ON LO–BOY CART
14
B
9
61 or 100
66
66
29
TO FIELD
32
TO ENGINE
WHITE
RED