Dyna-Glo M365GMDG14 Manual page 9

ASSEMBLY INSTRUCTIONS
5. Carefully place the grill body (I) onto the cart
left side panel and cart right side panel (E&F).
Adjust the grill body (I) so that the holes in
the grill body (I) are aligned with the holes in
the tabs of the cart side panels (E&F).
NOTE: Make sure the gas hose/regulator
assembly is inside the cart. Fasten the grill
body (I) using 2 screws (AA) and plain
washer (BB) on each side.
Hardware Used
M6x12 Screw
AA
BB
M6 Plain Washer
6. Install side table supports (J) with 2 M6x12
(AA) screws into holes (labeled 1) in side of
grill body (I) and tighten the screws. Repeat
with additional side table supports (J).
Hardware Used
AA M6x12 Screw
5
x 4
x 4
6
x 8
9
E
BB
J
1
AA
I
F
AA
I