Furuno FMD-3100 Manual page 41

80. Open the MSG function on the system
81. Read the latest NAVTEX message
82. Open the Safety tab
83. Create a new safety message to all ship on both channel A and B - stating:
Dead whale observed in port of Milford Haven on position 51°41'5N – 005°07'3W
84. Create manual position using LOP. Try all three types: Bearing, Distance and Bearing+ Distance.
85. Activate Dead Reckoning by LOP
86. Create a User Event and write" Pilot onboard" in description box.
87. Check your latest LOP, DR and User Event in your Voyage log
88. Show Track for the last 24 hours in the Voyage log
89. Change the time in the settings menu, to log positions every 2 hours
90. Set sensors from System to Local mode
91. Reset the Filter
92. Change the priority of the HDG in the sensor settings menu
93. Change the SPD stabilization mode to water
94. Reset the trip meter on the system
95. Make a backup on the route plans in the settings menu
96. Offset the EBL and VRM on the chart
97. Split the screen, and active the other window
98. Locate the Divider and make distance and bearing measurement on the chart
99. Activate the screen shot button and locate the picture, save the picture on the USB Flash
100. Change the Chart viewing dates to Auto
© FURUNO MARITIME TRAINING a part of Furuno Denmark A/S 2016. All rights reserved.
41
No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means,
electronic, mechanical, photocopying, recording or otherwise, without the prior written permission of FMT.
Z:\Training Courses\TST FMD\TST FMD {out of house}\03.17\04 Trainees Manual\Furuno ECDIS Trainee course manual version 4.0