Step 3.
Remove the memory module to be replaced by opening the retaining clips as shown.
Step 4.
Position the new memory module over the memory connector. Make sure that the notch
memory module aligns correctly with the connector key
module straight down into the connector until the retaining clips close.
Step 5.
Reattach the front bezel and computer cover.
Replacing the heat-sink assembly
To replace the heat-sink assembly:
Step 1.
Remove any media (disks, CDs, DVDs, or memory cards) from the drives, shut down the operating
system, and turn off the computer and all attached devices.
Step 2.
Unplug all power cords from electrical outlets.
Step 3.
Disconnect all cables attached to the computer. This includes power cords, input/output (I/O)
cables, and any other cables that are connected to the computer. Refer to "Left and right view"
and "Rear view" for help with locating the various connectors.
Step 4.
Remove the computer cover. Refer to "Removing the computer cover".
Step 5.
Remove the front bezel. Refer to "Removing the front bezel".
d
on the system board. Push the memory
.
Chapter 8
Replacing hardware
a b
c
on the
33