Manually Set Clock; Alarm - Oregon Scientific BAR610P User Manual

NOTE Reception takes 2-10 minutes. If the signal is
weak, it can take up to 24 hours to get a valid signal.
Clock signal reception indicator:
STRONG SIGNAL
NOTE Clock reception is dependent on the successful
transmission of data from remote sensor. If
displayed, press RESET on sensor and press UP and
DOWN together on the main unit and ensure sensor
has been successfully logged.

MANUALLY SET CLOCK

To set the clock manually, disable the clock signal
reception first.
1. Press and hold CLOCK SET.
2. Press UP / DOWN to change the settings.
3. Press CLOCK SET to confirm.
The settings order is: time zone, 12/24 hr format, hour,
minute.
BAR610P / BAR610PU: Time zone offset sets the
clock +/- 23 hours from the received clock signal time.
NOTE If you enter + 1 in the time offset setting, this will
give you your local time plus one hour. If you are in the
BAR610P_M_EN_R3.indd 5
WEAK / NO SIGNAL
is
5
Get other manuals https://www.bkmanuals.com
US (BAR610PA only) set the clock to:
0 for Pacific time +1 for Mountain time
+2 for Central time +3 for Eastern time

ALARM

To set the alarm:
1. Slide ALARM ON-OFF switch to ON.
2. Press and hold ALARM SET.
3. Press UP / DOWN to change the settings.
4. Press ALARM SET to confirm.
indicates alarm is on.
To activate / deactivate alarm:
Slide ALARM ON-OFF switch to ON / OFF.
•
To silence the alarm:
Press SNOOZE to silence it for 8 minutes
•
OR
Press any key to turn the alarm off and activate it
•
again after 24 hours.
12/9/08 17:55:47