INTRODUCTION Thank you for selecting the Oregon Scientific Wireless Weather Station (BAR608HA). This device bundles precise time keeping, weather forecast, barometric trend with altitude adjustment, and indoor and outdoor temperature and humidity monitoring features into a single tool you can use from the convenience of your home.
CHANGE SETTINGS GETTING STARTED Press and hold MODE for 2 seconds to enter setting BATTERIES mode. Batteries are not supplied with this product. You will need Press to change settings. to purchase 3 x UM-3 (AA) 1.5V alkaline batteries for Press MODE to confirm.
For best results: SETUP SENSOR • Insert the batteries and select the channel before Open the remote sensor battery compartment with you mount the sensor. a small Phillips screwdriver. • Place the sensor out of direct sunlight and Insert 2 alkaline batteries (UM-3 or "AA" size 1.5V), moisture.
DATA TRANSMISSION CLOCK Data is sent from the sensor(s) every 40 seconds. This product shows the current time, and day of week in The reception icon shown in the Temperature and English, French, German, Italian, or Spanish. The US Humidity Areas show the status. Atomic Clock in Boulder, Colorado automatically updates this information unless you disable the feature.
TURN ATOMIC CLOCK ON/OFF ALARMS Perform this step if you cannot receive Atomic Clock This product is equipped with a 2-minute crescendo signals. Press and hold for 2 seconds. Then, manually alarm. set the clock following the "Set Clock" instructions (below).
If no button is pressed, the alarm will automatically SET UNIT AND ALTITUDE silence after 2 minutes. It will then sound again after You can set the unit of measurement (mb/hPa or inHg) 8 minutes. and altitude. Doing this allows the product to take more accurate barometric measurements.
NOTE If you use a sensor that collects only TEMPERATURE AND HUMIDITY temperature data, humidity will not be shown. This product can display current, minimum, and maximum temperatures and humidity percentage information collected by the remote sensors and main MINIMUM / MAXIMUM RECORDS (indoor) unit.
Do not make any changes or modifications to this NOTE When you press RESET, all settings will return product. Unauthorized changes may void your right to to default value, and you will lose all stored information. use the product. The technical specification of this product and contents of this user guide are subject to SAFETY AND CARE change without notice.
PROBLEM SYMPTOM REMEDY SPECIFICATIONS Remote Cannot Check sensors. Only MAIN UNIT DIMENSIONS change one sensor is working sensor H x W x D 158 x 63 x 142 mm channel P.7) (6.2 x 2.5 x 5.5 inches) Data does Initiate a manual sensor Weight 366 g (12.96 ounces) not match...
RELATIVE HUMIDITY CLOCK Range 25% to 95% Atomic Clock Auto or manual (disabled) Resolution Clock display HH:MM:SS Memory Minimum / maximum Hour format 12hr AM/PM Time zone PA (Pacific), MO (Mountain), CE (Central) BAROMETER or EA (Eastern) Unit mb/hPa or inHg Calendar MM/DD;...
Visit our website (www.oregonscientific.com) to learn cause harmful interference to radio or television more about other Oregon Scientific products such as reception, which can be determined by turning the equipment off and on, the user is encouraged to try to...
Page 17
Name: Oregon Scientific, Inc. Address: 19861 SW 95 Place, Tualatin, Oregon 97062 USA IC: 3277A - BAR608HA Telephone No.: 1-800-853-8883 WIRELESS WEATHER STATION Fax No.: 1-503-684-8883 IC: 3277A - THGR238N declare that the product REMOTE THERMO-HYGRO SENSOR Product No.:...