GMC Hummer EV 2023 Owner's Manual page 240

GMC Hummer EV Owner Manual (GMNA-Localizing-MidEast-16569278) -
2023 - CRC - 1/25/23
240 Driving and Operating
AC Charge Cord Vehicle Plug
To Start AC Charging
1. Put the vehicle in P (Park).
2. The charge port door is on the rear
driver side of the vehicle. Push the
rearward edge of the charge port door
and release to open.
In cold weather conditions, ice may form
around the charge port door. Remove ice
from the area before attempting to open
or close the charge port door.
3. Plug the charge cord into the electrical
outlet. To verify the charge cord status,
see Electrical Requirements for Battery
Charging 0 252 and
Charge Cord 0 245. For instructions to
set cord limit settings for a charge
session, see Charging 0 111.
4. Plug in the AC charge cord into the
vehicle charge port. Make sure the AC
charge cord is fully connected to the AC
charge port. If it is not properly
connected, the vehicle may not be
charged.
5. Verify that the headlight Charging Status
Indicator (CSI) illuminates on the
headlamps (if enabled), charge port light
turns on, and an audible chirp occurs.
See Charging Status Feedback 0 243.
To End AC Charging
1. Unplug the charge cord from the vehicle.
2. Close the charge port door by pressing
firmly in the center until it latches.
3. Unplug the charge cord from the
electrical outlet.
4. Place the charge cord into the
storage case.
DC Charging
DC Charging Station Hardware
The vehicle can be charged using DC
charging equipment typically found at
service stations and other public locations.
Check the charging station DC charge cord
for compatibility with the DC charge port on
this vehicle. This vehicle is compatible with a
Combined Charging System 2 (CCS2)
connector.