GMC Canyon 2023 Owner's Manual page 277

GMC Canyon Owner Manual (GMNA-Localizing-MidEast-16512225) - 2023 -
CRC - 3/20/23
1. Assemble the wheel wrench (7) and the
two jack handle extensions (6), as shown.
2. Remove the hoist shaft access hole cover
on the bumper.
3. Insert the hoist end (open end) (9) of the
extension through the hole (8) in the
rear bumper.
Do not use the chiseled end of the wheel
wrench.
Be sure the hoist end of the
extension (9) connects to the hoist shaft.
The ribbed square end of the extension
is used to lower the spare tire.
4. Turn the wheel wrench counterclockwise
to lower the spare tire to the ground.
Continue to turn the wheel wrench until
the spare tire can be pulled out from
under the vehicle.
5. Pull the spare tire out from under the
vehicle.
6. Tilt the tire toward the vehicle with
some slack in the cable to access the
tire/wheel retainer.
Vehicle Care
Tilt the retainer and pull it through the
center of the wheel along with the cable
and spring.
7. Put the spare tire near the flat tire.
Removing the Flat Tire and Installing the
Spare Tire
Use the following pictures and instructions
to remove the flat tire and raise the vehicle.
277