Remote Control And Keyless Entry; Homelink - Chamberlain C400 Owner's Manual

Operation

Remote Control and Keyless Entry*

Pre-programmed remote control included, no need to program the remote.
To add or reprogram a remote control, follow the instructions below. Older Chamberlain remote controls are NOT
compatible, see page 41 for compatible accessories.
PROGRAM USING THE DOOR CONTROL
1. Press the LEARN button on the door control to enter Programming Mode.
2. Press the LEARN button again, the LED will flash once.
3. Remote Control: Press the button on the remote control that you wish to operate your garage door.
Keyless Entry: Enter a 4-digit personal identification number (PIN) of your choice on the keyless entry
keypad. Then press the ENTER button.
The garage door opener lights will flash (or two clicks will be heard) when the code has been programmed.
1
The command LED
will flash once.
3
* Not included with all models.
2
The command LED will
flash once again.
OR
? ? ? ?
PIN
PROGRAM USING THE LEARN BUTTON
1. Locate the Learn Button.
2. Press and immediately release the Learn button. The Learn LED will glow steady for 30 seconds. Within 30
seconds...
3. Remote Control: Press and hold the button on the remote control that you wish to use.
Keyless Entry: Enter a 4-digit personal identification number (PIN) of your choice on the keyless entry
keypad. Then press and hold the ENTER button.
Release the button when the garage door opener lights blink or two clicks are heard. When replacing the light lens
cover, ensure the antenna wires are hanging straight down.
1-2
LEARN
Button
LEARN LED
®

HomeLink

If your vehicle is equipped with HomeLink, a Compatibility Bridge
vehicles. Visit bridge.chamberlain.com to find out if a Bridge is needed.
36
3
PIN
TM (not included) may be necessary for certain