Replacing The Battery Cover; Charging Your Battery; Your Charger - Ericsson R300d User Manual

Replacing the Battery Cover

1 Insert the cover, bottom first, on the back of the phone.
2 Turn the screw clockwise to tighten the back.

Charging Your Battery

Your Charger

It is important that you fully charge your battery before you use your
phone. Your phone was packaged with either a wall charger or a
travel charger. Both chargers supply power to charge your battery
while the battery is attached to your phone. If your phone is On,
it can make or receive calls while using either charger.
Note! Never attach the charger to a phone that does not have a battery
installed.
1 If you have a wall charger, plug the charger into a standard
wall electrical outlet. If you have a travel charger, connect the
appropriate adapter to the travel charger.
2 Hold the phone with the display and keypad facing up.
3 Hold the small plug on the charger cord so the lightning bolt
symbol ( ) is up.
4 Align the small plug on the charger cord with the connector on
the bottom of your phone. The connector on the phone is above
the lightning bolt symbol ( ).
5 Press the plug into the connector until the plug "snaps" into place.
The icon continues to fill and empty until your battery is
fully charged. When charging is complete, the battery icon will
stop filling and emptying and will remain full (
Note! The amount of battery power indicated by your battery icon is
an estimate that may vary depending on your charging and use
patterns. To ensure adequate power supply, keep your battery fully
charged or carry additional charged batteries.
Note! Severely discharged batteries may not immediately indicate charging.
Note! Do not twist while inserting or removing the small plug on the
charger cord!
6 Continue charging the phone until the battery is fully charged.
7 To disconnect the charger, lift the plug connected to the phone
upwards and pull it out.
Getting Started
).
9