Table of Contents
Advertisement
Figure 45
1. Mark the cable here
Figure 46
1. Slack—11 mm (7/16 inch)
8.
Torque the cable-clamp screw to 11 to 14 N∙m
(99 to 121 in-lb) to lock the adjustment in place.
9.
Install the belt cover with the 4 bolts that you
removed in step 3.
10.
Connect the wire to the spark plug.
11.
Check the operation of the blade-brake clutch.
Changing the Transmission
Belt
Service Interval: Every 250 hours
Removing the Transmission Belt
Note:
Retain all hardware removed in this procedure,
except the old transmission belt, for installation in
Installing the Transmission Belt (page
1.
Shut off the engine and wait for all moving parts
to stop.
2.
Disconnect the wire from the spark plug.
3.
4.
5.
6.
7.
8.
g208923
1. Rear-viewing window
g208920
9.
33).
1. Trailing shield
32
Remove the 4 bolts that hold the belt cover to
the machine housing.
Remove the belt cover.
Remove any debris from under the belt cover.
If the grass bag is on the machine, remove it.
Refer to
Removing the Grass Bag (page
Raise and hold up the rear deflector.
Remove the rear-viewing window, located under
the rear-discharge deflector, by removing the
bolt holding it in place
Figure 47
Remove the trailing shield by removing the 2
bolts holding it in place
Figure 48
18).
(Figure
47).
g280620
2. Rear-viewing-window bolt
(Figure
48).
g280624
2. Trailing-shield bolts
Advertisement
Table of Contents
