Messages - Tascam DR-701D Owner's Manual

Messages

The following is a list of the pop-up messages.
Refer to this list if one of these pop-up messages
appears on the DR-701D and you want to check the
meaning or determine a proper response.
Message Meaning and response
The batteries are almost out of
Battery Empty
power. Replace the batteries.
The SD card could not be recog-
Card Error
nized properly. Change the card.
The SD card has no remaining
space. Erase unnecessary files
Card Full
or move them to a computer to
make open space.
The total number of folders
and files exceeds the 5000
File Full limit. Erase unnecessary folders
and files or move them to a
computer.
A file cannot be found or a file
File Not Found might be damaged. Please
check that file.
The system file is missing. This
unit requires a system file for
File Not Found operation. When this message
appears, press the DATA dial to
Make Sys File
automatically create a system
file.
The file is read only and cannot
File Protected
be erased.
The SD card is not formatted
properly or the card is broken.
This message also appears if
the card was formatted using
a computer connected by USB
or if an unformatted card is
inserted in the unit.
Format Error
Format CARD Always use the DR-701D to
format cards to be used with it.
Change the card or press the
DATA dial while this message is
being shown to format the card.
Formatting will erase all the
data on the SD card.
Something might be wrong
Invalid Card
with the SD card. Change the
Change Card
SD card.
The system file required to
operate this unit is invalid.
Invalid SysFile
When this message appears,
Make Sys File
press the DATA dial to automat-
ically create a new system file.
Folders can be created down to
two layers. You cannot create
Layer too Deep
a new folder inside the current
folder.
Message Meaning and response
The SD card is not formatted
properly or the card is broken.
Change the card or press the
MBR Error Init
DATA dial while this message is
CARD
being shown to format the card.
Formatting will erase all the
data on the SD card.
No SD card is loaded in the unit.
No Card
Insert a recordable SD card.
There is no file that can be
No PB File played back. The file might be
damaged.
The audio file is not a
supported format. Please see
Non-Supported "Connecting with a Computer"
in the Reference Manual for file
formats that this unit can use.
The power source has switched
Switched To
from USB bus power to the
Internal Battery
batteries in the unit.
Writing to the SD card timed
out.
Write Timeout
Backup files on the card to a
computer, and format the card.
No Rec Channels No recording channels have
Selected been selected (all are off ).
HDMI has been connected.
HDMI CONNECTED
The clock master will switch to
LOCK to HDMI.
HDMI.
HDMI has been disconnected.
HDMI DISCON-
NECTED
The clock master will switch to
LOCK to INTERNAL
internal.
-HDMI
HDMI has been connected.
CONNECTED-
Mismatch Audio
The sampling frequency is
Clock.
different. Change it?
Change to **kHz?
The sampling frequency has
been changed.
Fs Mismatch
LOCK to INTERNAL
The clock master will switch to
internal.
The sampling frequency has
been changed.
Fs Match
LOCK to HDMI.
The clock master will switch to
HDMI.
If any other error occurs, turn the unit off and restart
it.
17
TASCAM DR-701D