Yamaha TT-R50EL 2019 Owner's Manual page 74

Periodic maintenance and adjustment
4. Place the motorcycle on a mainte-
nance stand. WARNING!
avoid injury, securely support
the vehicle so there is no danger
of it falling over.
5. Remove the axle nut, washer and
the drive chain puller at the left
side, then pull the wheel axle out
together with the drive chain puller
from the right side.
1. Wheel axle
7
6. Push the wheel forward, and then
remove the drive chain from the
rear sprocket.
TIP
The drive chain does not need to be
disassembled in order to remove and
install the wheel.
7. Remove the wheel.
To
[EWA10752]
1
7-32
To install the rear wheel
1. Install the drive chain onto the rear
sprocket, lift the rear wheel off the
ground, and then install the wheel
by inserting the wheel axle togeth-
er with the drive chain puller from
the right side.
TIP
Make sure that the slot in the brake
shoe plate fits over the retainer on the
swingarm.
1. Slot
2. Retainer
2. Install the drive chain puller at the
left side, washer and axle nut.
3. Take the motorcycle off the main-
tenance stand and put the side-
stand down.
4. Connect the brake rod to the
brake camshaft lever, and then in-
stall the brake pedal free play ad-
justing nut onto the brake rod.
5. Check and adjust the drive chain
slack. (See page 7-20.)
6. Adjust the brake pedal free play.
(See page 7-18.)