Output Data; Heading - Furuno SC-50 Operator's Manual

DISABLE SV (Disable satellite)
Every GPS satellite is broadcasting abnormal satellite number(s) in its Almanac,
which contains general orbital data about all GPS satellites. Using this
information, the GPS receiver automatically eliminates any malfunctioning
satellite from the GPS satellite schedule. However, the Almanac sometimes may
not contain this information. If you hear of an inoperative satellite you can
disable it manually. Enter satellite number in two digits and then press the [ENT]
key. To restore a satellite, enter "00".
3.8

Output Data

3.8.1

Heading

Heading data is output from the HDG OUT port on the processor unit, in IEC
61162-1/2 format.
1. Press the [MENU] key to open the menu.
2. Choose I/O SETUP and then press the [ENT] key.
3. Choose DATA OUT1 and then press the [ENT] key.
4. Use the Omnipad to choose AD-10 or IEC as appropriate and then press the
[ENT] key. If you choose AD-10, no further operation is required; go to step
19 to finish. For IEC go to the next step.
OUTPUT DATA SETUP
DATA OUT1: AD-10
DATA OUT2: AD-10
DATA OUT3: IEC
DATA OUT4: IEC
DATA OUT5: IEC
LOG PULSE: 200 P/NM
OUTPUT DATA SETUP menu
AD-10
IEC
Data out options
DATA OUT1
SENTENCE: HDG VTG ROT
HDT HDM VDR HVE VTG GGA GNS
GLL ZDA VHW VBW
BAUD RATE: 4800BPS
INTERVAL: 25mS
NMEA VER: IEC ED2
HDG TALKER: GP
DATA OUT1 menu
Get other manuals https://www.bkmanuals.com
3. OPERATION
3-9