Table of Contents
Advertisement
• Beard trimmings may clog the drain at
the bottom of the cleaning tray.
In this case, you cannot clean or dry the
shaver.
1. Be sure to remove the AC adaptor
from the self‑cleaning recharger.
2. Place the self‑cleaning recharger on a
flat surface, and push the beard
trimmings down through the drain (b)
with a toothpick etc.
►Replacement parts
Replacement parts are available at your dealer or
Service Centre.
Replacement parts
for ES‑LS9A
Special Detergent for Shaver Cleaning &
Charging System
ES-LS9A_AUS.indb
19
System outer foil
WES9600
WES4L03
When the LOW/STATUS lamp glows
It indicates that the cleaning liquid is due for
replacement when the LOW lamp or STATUS lamp
glows for approximately 5 seconds when the SELECT
button is pressed.
Lamp on the self-
cleaning recharger
The LOW lamp glows.
The STATUS lamp
glows.
Content of notification
Replacement of the
cleaning liquid is required in
approximately 7 days.
Prepare the detergent.
Replace the cleaning liquid.
(Modes other than the
"AUTO" mode can be used
even if it is not replaced.)
If you think the replacement
should not be due yet.
• Is the cleaning liquid unit
correctly attached?
• Is the self‑cleaning
recharger placed in a level
surface?
• Is the self‑cleaning
recharger used outside the
range of the recommended
usage temperature?
(Only "Charge" mode can
be used.)
19
2022/08/31
11:19:05
Advertisement
Table of Contents
