Table of Contents
Advertisement
Preparation
Charging the shaver
• Turn the shaver off.
• Wipe off any water droplets on the main body rear
terminals.
1
Insert the appliance plug
into the self-cleaning
recharger.
2
Remove the protective cap
while pressing the side of
the cap and insert the
shaver into the self-
cleaning recharger.
• Slowly insert the shaver into
the self‑cleaning recharger
taking care not to damage the
system outer foil.
3
Plug the adaptor into a household outlet.
• Check that the charge status lamp ( ) is glowing.
• Charging is completed after approx. 1 hour.
4
Disconnect the adaptor after charging is
completed.
Quick charge
Even though the battery runs out, you can shave
once after 3‑minute charge.
(This will differ depending on usage.)
10
ES-LS9A_AUS.indb
10
glows.
The number of the battery
capacity lamp will increase
as charging progresses.
2
3
Notes
• When charging the shaver for the first time or when it
has not been in use for more than 6 months, the
1
charging time may change or the charge status lamp
( ) may not glow for a few minutes. It will eventually
glow if kept connected.
• Recommended ambient temperature for charging is
10 °C – 35 °C. It may take longer to charge, or the
charge status lamp ( ) will blink quickly and the
battery may fail to charge properly in extremely high
or low temperatures.
• The shaver can be used for approximately 2 weeks
with a full charge.
(Based on one 3‑minute dry‑shave usage per day in
an ambient temperature range of 20 °C – 30 °C.)
The number of usable days varies depending on the
following conditions.
‑ Beard thickness
‑ Pressure applied to the skin
‑ Usage frequency of the sonic vibration cleaning mode
While charging
"100%" appears and then
turns off after 5 seconds.
After charging is
completed
2022/08/31
11:19:01
Advertisement
Table of Contents
