Table of Contents
Advertisement
declared load for the set programme
(only for a few seconds), the default
temperature, the default spin speed and
the washing phase indicators (when
available).
2. To change the temperature and/or
the spin speed, touch the related
buttons.
3. If desired, set one or more options by
touching the related buttons. The
related indicators come on in the
display and the given information
changes accordingly.
In case a selection is not
possible, no indicator
comes on and an acoustic
signal sounds.
13.5 Starting a programme
Touch the Start/Pause
the programme.
The related indicator stops flashing and
stays on.
In the display, the indicator of the
operating phase starts flashing.
The programme starts, the door is
locked. The display shows the indicator
.
The drain pump can operate
shortly before the appliance
fills water.
13.6 Starting a programme
with the Finish In option
1. Touch this repeatedly until the
display shows the desired time within
the programme should end. The
indicator
comes on.
2. Touch the Start/Pause
The drum starts rotating to perform the
ProSense estimation, if foreseen in the
selected programme.
3. The appliance starts the countdown
to the end of the programme and the
programme will start at the right
moment for ending at the time set
through this option.
To change or cancel this
option:
1. Switch the appliance off by means of
2. Switch the appliance on again.
3. Set the programme again.
13.7 The ProSense load
detection
After setting a washing programme, the
the programme supports it.
After touching the Start/Pause
button, the ProSense starts the laundry
button to start
load detection:
1. The appliance detects the load in the
2. When the drum stops rotating, the
button.
the On/Off button.
The programme duration in
the display is referred to a
medium/high load.
icon lights up on the display if
first 30 seconds: the indicator
flashes, the bars under the
icon move back and forth and the
drum rotates shortly.
display shows the new programme
duration, that could increase or
decrease, adjusted accordingly the
load detected, the number of bars
indicates the load in quarter (from 1
to 4, 4 bars in case of overload), the
maximum declared load indicator
comes on again. After further 30
seconds, the water filling starts.
ENGLISH
35
Advertisement
Table of Contents
