Table of Contents
Advertisement
I. Startup
All parts are factory-adjusted. Improper adjustments may adversely affect safety,
performance, component life, and warranty coverage.
• If the icemaker is turned off, wait for at least 3 minutes before restarting the
icemaker to prevent damage to the compressor.
• To prevent damage to the water pump, do not leave the control switch in the
"PUMP" position for extended periods when the water tank is empty.
• At startup, confirm that all internal and external connections are free of leaks.
Additional Notice for Remote Models
• The icemaker must have power for a minimum of 4 hours prior to startup to
prevent compressor damage.
1) Open the water supply line shut-off valve(s).
2) If not already removed, remove the front panel. See Fig. 17.
3) Move the mode switch on the control box
to the "ICE" position, then move the control
switch to the "ON" position.
4) Replace the front panel in its correct
position.
5) Turn on the power supply, and allow the
icemaker to operate for a total of 10 min.
6) After 10 min. of operation, remove the front panel, then move the control switch to the
"OFF" position. Turn off the power supply.
7) Remove the front insulation panel. Next, remove the drain
plug located in the bottom of the water tank. Allow the water
tank to drain. See Fig. 18.
8) After the water tank has drained, replace the drain plug in its
correct position. Be careful not to cross thread the drain plug.
9) Clean the dispenser unit/ice storage bin liner using a neutral
cleaner. Rinse thoroughly after cleaning.
10) Replace the front insulation panel and front panel in their correct positions, then turn on
the power supply to start the automatic icemaking process.
11) When the icemaker is running, hold ice in contact with the bin control thermostat bulb.
The icemaker should stop within 10 seconds. Adjustment may be needed, particularly at
higher altitude locations.
12) On water-cooled models, confirm proper condenser drain outlet/return outlet
temperature as outlined in "II.F.2. Water-Cooled Condenser."
WARNING
NOTICE
Front Panel
30
Icemaker
Mode Switch
Fig. 17
Control Switch
Drain
Plug
Fig. 18
Advertisement
Table of Contents
