Uninstalling The Hardware - National Instruments NI 6581 Getting Started Manual

1. Remove the captive screw covers.
2. Install the PXI EMC filler panels by securing the captive mounting screws to the chassis,
as shown in the figure below. Make sure that the EMC gasket is on the right side of the
PXI EMC filler panel.
1
2
1. Captive Screw Covers
2. Captive Mounting Screws
3. EMC Gasket
Note
ensure proper module cooling. Do not over tighten screws (2.5 lb · in.
maximum). For additional information about the use of PXI EMC filler panels
in your PXI system, visit

Uninstalling the Hardware

Hot Surface
temperatures and cause burns. Allow the module to cool before removing it from the
chassis.
1.
Caution
to the NI 6581/6581B front panel. Applying external signals while the device is
powered off may cause damage.
Disconnect any cables from the module front panel connectors.
2. Power off the chassis.
Figure 13. PXI EMC Filler Panels and Chassis
3
1
You must populate all slots with a module or a PXI EMC filler panel to
ni.com/info
If the module has been in use, it may exceed safe handling
Disconnect or disable any external RF, clock, or digital connections
NI 6581/6581B Getting Started Guide | © National Instruments | 17
and enter
emcpanels
.