Manually Creating A Connection To The Wireless Lan Access Points; Setting The Network Preferences For - Sony CLIE PEG-TH55 Handbook

Setting the Network preferences for a wireless LAN
When you disable [PowerSaveMode:]
Disable [PowerSaveMode:] for communicating with maximum power
when the wireless LAN is unstable. However, the battery power is quickly
consumed.
Select [PowerSaveMode:] for normal use.
When you need to select [Authentication:]
When any option other than [None] is selected for [WEP :] in C of step
6, you may need to select either [Open System] or [Shared KEY]
depending on your wireless LAN access point. In this case, select either
[Open System] or [Shared KEY].
Tip
You can register up to 30 profiles on your CLIÉ handheld.
7
Tap [OK] after configuring the settings.
The profile list is displayed in the Wireless LAN Setup screen. The
profile you configured is added to the list.
Tip
If multiple profiles are registered and [-Auto Connect-] is selected, profiles are
selected in order from the top of the list down. To rearrange the list order, select a
profile you want to move and tap either
8
Tap [OK].
The Preferences screen for [Network] is displayed again.
Manually creating a connection to the wireless LAN access
points
If no wireless LAN access point is found, you can register a profile on your
CLIÉ handheld manually. Follow the steps below.
1
Tap V at the top right of the Preferences screen, and select
[Network].
2
Tap [V Service:], and select [Wireless LAN].
Customizing your CLIÉ™ handheld (Preferences)
or in the right of the screen.
Continued on next page
• • • • • • • • • • • • • • • • • • •
107