Steps
1. Place the fan and heat-sink assembly on the system board and align the screw holes on the fan and heat-sink assembly with
the screw holes on the system board.
2. In reverse sequential order (6>5>4>3>2>1), replace the six screws that secure the fan and heat-sink assembly to the system
board.
3. Turn the system-board assembly over.
Next steps
1. Install the
system
board.
2. Install the
memory
module.
3. Install the
wireless
card.
4. Install the
solid-state
5. Install the
rear
cover.
6. Install the battery.
7. Install the
base
cover.
8. Follow the procedure in
Power-button assembly
Removing the power button
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the battery.
4. Remove the
rear
cover.
5. Remove the
solid-state
6. Remove the
wireless
card.
drive.
After working inside your
Before working inside your
drive.
computer.
computer.
Removing and installing Field Replaceable Units (FRUs)
83