Power-Button Assembly; Removing The Power Button - Dell NOT22107 Owner's Manual

Steps
1. Place the fan and heat-sink assembly on the system board and align the screw holes on the fan and heat-sink assembly with
the screw holes on the system board.
2. In reverse sequential order (7>6>5>4>3>2>1), replace the seven screws that secure the fan and heat-sink assembly to the
system board.
3. Turn the system-board assembly over.
Next steps
1. Install the system board.
2. Install the memory module.
3. Install the wireless card.
4. Install the solid-state
5. Install the rear cover.
6. Install the battery.
7. Install the base cover.
8. Follow the procedure in

Power-button assembly

Removing the power button

Prerequisites
1. Follow the procedure in
2. Remove the base cover.
3. Remove the battery.
4. Remove the rear cover.
5. Remove the solid-state
6. Remove the wireless card.
7. Remove the memory module.
8. Remove the system board.
82 Removing and installing Field Replaceable Units (FRUs)
drive.
After working inside your
Before working inside your
drive.
computer.
computer.