Chain Oiler - Craftsman 358.351080 Operator's Manual

• :,k!
.r . _"
r ,
OPERATION
HOWTO USE YOUR CHAIN SAW
STOPPING YOUR ENGINE
' Move on/stop switch to the "Stop"position.
, If engine does not stop, pull b_uechokeknob out fully.
CHAIN OILER (Fig. 7)
• The chain oiler provides continuouslubricationto the
chain and guide bar. Be sure to figthe bar oil tank when
you fillthe fuel tank (Capacity = 6.8 fl, oz.).
• Your chain saw will consume approximately one tank of
CHOKE/FAST IDLE SPEED
• The choke and fast idle speed are set by pulling the
choke lever out fully for cold or refueled engine starts.
• Squeezing the throttletrigger will release the choke and
fast idle settings.If the throttletrigger is squeezed acci-
dentally during starling, it will be necessary to reset
throttle advance by pullingchoke lever out fully.
• The choke providesadditionalfuel when starting a cold
engine.
• The choke is actuated by pullingthe blue choke knob,
• The choke has two positions: off and full.
bar oil for each tank of fuel used.
• Your chainoiler is automatic and requiresno adjustment.
Handle
Bar
Oil Fill Fuel Mix Cap
Figure 7
THRO'n'LE CONTROL GROUP (Fig. 8)
THROTTLE LOCKOUT
• The throttle lockout prevents unintentionalactuation of
the throttletrigger.
° You must depress the throttle lockoutwith the palm of
your hand before actuating the throttletrigger.
THROTTLE TRIGGER
• The throttle trigger allows for vadable controlof engine
speed.
• The throttle trigger is actuated by the indexfinger on your
dght hand. (After the throttlelockoutis depressed).
Throttle
Lockout
Throttle
Figure 8
Figure 9
".:::?