Craftsman 358.351080 Operator's Manual page 24

r _,.:
SERVICE AND ADJUSTMENTS
• Pull out 10" of rope and catch rope in notch in the pulley.
• Carefully turn the pulley two complete turns clockwise,
keeping the rope againstthe notchto wind the spdng.
• While holding the pulley ratchet, pull the excess rope
through the starter rope hole.While holding tension on
the rope, let rope slowlyrewind into the housing.
• Reinstall fan housing by aligningthe fan housing to the
chassis.Then while holdingthe fan housing against the
chassis, pull the rope handle out until you feet the fan
housing drop into place against thechassis. Slowly, let
the rope rewind into starter housing.
• Reinstall the 4 fan housing screws and tighten the 2
cylinder cover screws. Figure 44.
Wind Up Spring
Rewind for-
Tension
Figure48
"C_'-
°
_T. _ ._
r
• - 24-