Table of Contents
Advertisement
waxes or solvents to clean the unit.
‡
Disconnect the power plug from AC outlet if the product is not being used for a long period of time.
‡
Do not setup the projector in places where it might be subjected to vibration or shock.
‡
Do not touch the lens with bare hands.
‡
Remove battery/batteries from remote control before storage. If the battery/batteries are left in the
remote for long periods, they may leak.
‡
Do not use or store the projector in places where smoke from oil or cigarettes may be present, as it
can adversely affect the quality of the projector performance.
‡
Please follow the correct projector orientation installation as non standard installation may affect the
projector performance.
‡
Use a power strip and or surge protector. As power outages and brown-outs can KILL devices.
Laser Radiation Safety Information
‡
Complies with 21 CFR 1040.10 and 1040.11 except for conformance as a Risk Group 2 LIP as defined
in IEC 62471-5:Ed. 1.0. For more information see Laser Notice No. 57, dated May 8, 2019
IEC 60825-1:2014, EN 60825 1 2014 A11 2021, EN 50689:2021 CLASS 1 CONSUMER
LASER PRODUCT RISK GROUP 2, Complies with 21 CFR 1040.10 and 1040.11 except for
conformance as a Risk Group 2 LIP as defined in IEC 62471-5:Ed.1.0. For more information
see Laser Notice No. 57, dated May 8, 2019.
IEC 60825-1:2014
IEC 60825-1:2014 1
Failure to comply with the following could result in death or serious injury.
‡
This projector has built-in Class 4 laser module. Disassembly or modification is very dangerous and
should never be attempted.
‡
Any operation or adjustment not specifically instructed by the user's guide creates the risk of
hazardous laser radiation exposure.
‡
Do not open or disassemble the projector as htis may cause damage by the exposure of laser
radiation.
‡
Do not stare into beam when the projector is on. The bright light may result in permanent eye damage.
‡
When turning on the projector, make sure no one within projection range is looking at the lens.
‡
Without following the control, adjustment or operation procedure may cause damage by the exposure
of laser radiation.
‡
Adequate instructions for assembly, operation, and maintenance, including clear warnings concerning
precautions to avoid possible exposure to laser.
‡
IEC 60825-1: 2014 Class 1 RG2
IEC 62471-5:2015 RG2
‡
Additional instructions to supervise children, no staring, and not use optical aids.
‡
Additional instructions to install above the reach of children.
‡
Notice is given to supervise children and to never allow them to stare into the projector beam at any
distance from the projector.
‡
Notice is given to use caution when using the remote control for starting the projector while in front of
the projection lens.
‡
Notice is given to the user to avoid the use of optical aids such as binoculars or telescopes inside the
beam.
‡
As with any bright light source, do not stare into the beam, RG2 IEC 62471-5:2015.
‡
WARNING: MOUNT ABOVE THE HEADS OF CHILDREN. The use of a ceiling mount is
recommended with this product to place it above the eyes of children.
- :
+
:
1
RG2
RG2
5
English
Advertisement
Table of Contents
