Table of Contents
Advertisement
Power
Input Selection
Control Web Pages,
The Power button turns the display on and off.
Refer to the following table to determine the status of the display:
If the Power button is...
Depressed and the indicator
light is green
Not depressed and the
indicator light is red
Not depressed and the
indicator light is gray
To turn a display on, perform the following steps:
1.
Press the Power button. The button remains depressed
and the indicator light turns green.
To change a display to standby mode, perform the following
steps:
1.
With the Power button depressed, press the button again.
The button returns to the original position and the
indicator light turns red.
The Input Selection section allows you to select the source of the
input signal to the EBS-N200.
The device and model displayed in the General Information
section determine the buttons available in this section.
To change the input selection, perform the following steps:
1.
Press the button corresponding to the input selection you
want to activate. If the command is successful, the display
displays video from that input. If the command is not
successful, the button returns to its original position.
EBS-N200 Network Display Adapter
continued
Then, the display is...
Turned on
In standby mode
Undefined or error condition
25
Advertisement
Table of Contents
